Service Mode Table
G133 5-298 SM
001 A3/DLT *ENG
[0 to 960 / 323 / 1 PULSE/step]
002 B4 *ENG
[0 to 960 / 381 / 1 PULSE/step]
003 A4/LT *ENG
[0 to 960 / 400 / 1 PULSE/step]
004 B5 *ENG
[0 to 960 / 498 / 1 PULSE/step]
005 A5/HLT *ENG
[0 to 960 / 525 / 1 PULSE/step]
006 B6 *ENG
[0 to 960 / 525 / 1 PULSE/step]
007 A6 *ENG
[0 to 960 / 525 / 1 PULSE/step]
[Repeat Print Temp.Correction]
9965
These SPs are used for Preventing the fusing temperature overheating due to
a multiple printing job.
JOB Interval: Plain *ENG
[0 to 120 / 30 / 1 sec/step]
001
Specifies the job interval time in plain paper mode. The machine does not enter
the temperature correction mode for preventing the overheating for the time
specified with this SP.
JOB Interval: M-Thick *ENG
[0 to 120 / 30 / 1 sec/step]
002
Specifies the job interval time in middle thick paper mode. The machine does
not enter the temperature correction mode for preventing the overheating for
the time specified with this SP.
Shift Time *ENG
[0 to 1200 / 600 / 10 sec/step]
003
Specifies the threshold time for entering the temperature correction mode. If a
job continues for the time specified with this SP, the machine enteres the
temperature correction mode.
Offset Value: Plain: Low
Temp .
*ENG
[0 to 20 / 5 / 1 deg/step]
004
Specified the offset temperature for the plain paper in the low temperature. The
machine decreases this temperature when a job continues for 600 seconds
To Next Page
Loading...
