Tray Heater (Optional Tray)
SM 1-51 G133
Installation
4. Remove the two securing brackets [B] ( x 1 each), and then the rear cover [C] of the
optional paper tray ( x 2).
5. Remove the harness cover bracket [D] ( x 1).
6. Pull out tray 2 from the mainframe.
7. Replace the shoulder screw [E] with the washer screw [F], using the securing bracket
[G] ( x 1).
8. Connect the harness [H] to the connector [I] of the tray heater.
9. Route the harness [H] as shown and clamp it with four clamps (= x 4).
Make sure that the harness [H] is placed below the harness [J].
10. Connect one harness [K] of the two-way harness to the connector [L] of the mainframe.
Connect [K] to the connector on the mainframe. The harness of connector [K]
has two binders. The harness of the other connector [M] has one binder, and
this is for another optional paper feed unit.
To Next Page
Loading...
