G147 5-10 SM
feeding thick paper with the by-pass tray.
[120°C ~ 220°C / 200°C / 1°C step]
008 End (Bypass) T
Adjusts the temperature of the ends of the hot roller for
feeding thick paper with the by-pass tray.
[120°C ~ 220°C / 200°C / 1°C step]
009 Ctr (Thick)
Adjusts the temperature for re-heating the center of the
hot roller for feeding thick paper:
Reload Temp. = Fusing. Temp – SP Value
[0°C ~ 60°C / 5°C / 1°C step]
When the fusing temperature exceeds this setting, the
machine can operate.
Do not set a reload temperature (Spec. Temp – SP
Value) higher than the SP1105-02 setting.
010 Ends (Thick)
Adjusts the temperature for re-heating the ends of the
hot roller for feeding thick paper:
Reload Temp. = Fusing. Temp – SP Value
[0°C ~ 60°C / 5°C / 1°C step]
When the fusing temperature exceeds this setting, the
machine can operate.
Do not set a reload temperature (Spec. Temp – SP
Value) higher than the SP1105-02 setting.
1106 Fusing T Disp. Fusing Temperature Display
001 Roller Center
Displays the fusing temperature for the center of the hot
roller.
002 Roller Ends
Displays the fusing temperature for the ends of the hot
roller.
003 I/O Board Temp.
Displays in the internal temperature of the machine
when it was powered on.
To Next Page
Loading...
