G147 1-32 SM
1. Remove the cover [1] of board Slot 1 or 2 (
x1)
2. Install the interface board [2] (
x2 knob screws)
Use a screwdriver to tighten the knob-screws. Do not tighten manually because
this can disconnect the board.
3. Reattach the application cover (
x1)
IEEE 802.11b Interface Kit (G813)
- Accessories -
Check the accessories and their quantities against the following list:
No. Description Q'ty
1. IEEE 802.11b Board 1
2. PCI Card 1
- Procedure -
Turn off the power switch and disconnect the power supply cord.
You can only install one of these network interfaces: IEEE 802.11b (Wireless LAN),
IEEE1284 (Centronics), or Gigabit Ethernet Board.
To Next Page
Loading...
