SM 1-33 G147
Installation
1. Remove the cover [1] of board Slot 1 or 2 (
x1)
2. Attach the interface board [2] to the controller board (
x1 knob screw).
Use a screwdriver to tighten the knob-screws. Do not tighten manually,
because this can disconnect the board.
3. With the printed side facing the front of the machine, insert the interface card [3]
board.
4. Attach the antenna cap [4].
- SP Mode Settings for IEEE 802.11b Wireless LAN -
The following SP commands and UP modes can be set for IEEE 802.11b
SP No. Name Function
5840 006 Channel MAX
Sets the maximum range of the channel settings for the
country.
5840 007 Channel MIN
Sets the minimum range of the channels settings allowed
for your country.
5840 011 WEP Key Select Used to select the WEP key (Default: 00).
USB Host Interface Unit Type 7300 (G819)
- Accessories -
To Next Page
Loading...
