By-pass
SM 3-55 G179
Replacement
Adjustment
3.12 BY-PASS
3.12.1 BY-PASS PAPER SIZE SENSOR
1. Open the by-pass tray [A].
2. Move the side fences to the center.
3. By-pass tray cover [B] ( x 4)
4. By-pass paper size sensor [C] ( x 1)
When reinstalling the by-pass paper size sensor
1. Adjust the projection [E] of the left side fence bar (it must be centered).
2. Install the by-pass paper size sensor so that the hole [D] in this sensor faces the
projection [E] of the left side fence bar.
3. Reassemble the machine.
4. Plug in and turn on the main power switch.
5. Check this switch operation with SP5803-024 (By-pass paper size < Input Check).
To Next Page
Loading...
