Ricoh G179 - 4.11 SC TABLES: SC8 XX -2

SC Tables: SC8xx -2
G179 4-34 SM
4.11 SC TABLES: SC8XX -2
HDD startup error at main power on
 HDD is connected but a driver error is detected.
 The driver does not respond with the HDD within 30 s.
860
CTL
B
 HDD is not initialized
 Label data is corrupted
 Defective HDD
Initialize the HDD with SP5832-001.
HDD re-try failure
At power on, the HDD is detected. Power supply to the HDD is interrupted
after the system has entered the energy save mode, but after the HDD has
been awakened from the energy save mode, it does not return to the ready
status within 30 sec.
861
CTL
D
 Harness between HDD and controller board disconnected, defective
 HDD power connector disconnected
 HDD defective
 Controller board defective
HDD data read failure
The data written to the HDD cannot be read normally, due to bad sectors
generated during operation.
863
CTL
D
 HDD defective
Note: If the bad sectors are generated at the image partition, the bad sector
information is written to NVRAM, and the next time the HDD is accessed,
these bad sectors will not be accessed for read/write operation.
HDD data CRC error
864 CTL
D
During HDD operation, the HDD cannot respond to a CRC error query. Data
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA