6
Downloading Images Without
Using DL‑10
1.
Make sure that the camera power is
off.
2.
Connect the accessory USB cable to
a USB port of your computer.
3.
Connect the USB cable to the USB
terminal of your camera.
Your camera turns on.
Your computer automatically reads the file
necessary for recognizing the camera as a
drive.
After this preparation, the camera is
displayed as a drive at [My Computer].
Example of the display in Windows XP
4.
From the displayed drive, copy a
file to the desired location.
The figure below shows the folder
configuration of the drive.
When the contents of the internal memory
are displayed, the drive name is [RICOHDCI].
• If a file with the same name already exists at
the destination, it is overwritten.
• If DC Software is installed, clear the check
box next to the [Saves automatically when
connected to USB] option in the DL-10 [Option
settings] dialog box.
To Next Page
Loading...
