45
2. Optional Functions
Optional Document Feeder
Insert a stack of originals in the docu-
ment feeder. They will be fed auto-
matically.
Originals
Placing the following originals in the
document feeder might cause mis-
feeds or damage to the originals.
Place the following kinds of originals
on the exposure glass:
• Originals heavier than 127.9g/m
2
,
34 lb
• Originals lighter than 52.3g/m
2
, 14 lb
• Originals smaller than 148mm ×
210mm, 5.9" × 8.3"
• Originals larger than 297mm ×
864mm, 11.6" × 34.0"
• Stapled or clipped originals
• Perforated or torn originals
• Curled, folded, or creased origi-
nals
• Originals with any kind of coating,
such as thermal fax paper, art pa-
per, aluminum foil, carbon paper,
or conductive paper
• Bound originals such as books
• Damaged originals
• Originals with glue on them
• Pasted originals
• Originals written in pencil
• Thin originals that are a little stiff
• Originals with index tabs
• Transparent originals such as OHP
transparencies or translucent pa-
per
The following original sizes placed in
the document feeder can be detected.
Note
❒ Place originals after correction flu-
id and ink have completely dried.
Not taking this precaution could
mark the exposure glass and cause
marks to be printed.
For standard printing functions, set
originals as shown below.
You cannot place originals of differ-
ent sizes at the same time.
When you use thin originals, place
one original at a time in the document
feeder or place them on the exposure
glass.
The first 5mm, 0.2", of the leading
edge and the last 2mm, 0.08" of the
trailing edge cannot be printed. Make
sure the leading edge margin is at
least 5mm, 0.2", and the trailing edge
margin is at least 2mm, 0.08".
Do not stack originals above the limit
mark.
Metric version A3
L
, B4
L
, A4
KL
,
B5
KL
, A5
KL
Inch version 11"
×
17"
L
, 8
1
/
2
"
×
14"
L
, 8
1
/
2
"
×
11"
KL
, 5
1
/
2
"
×
8
1
/
2
"
KL
R
R
GRSETT1E
PinkGold-F_V4_FM.book Page 45 Tuesday, May 27, 2003 3:33 PM
To Next Page
Loading...
