Ricoh Gestetner 5430 - When x and C light

Replenishing Supplies
68
4
Master Roll Replacement
The master end indicator (C) is lit
when it is time to replace the master
roll.
A
AA
A
Pull out the master tray.
B
BB
B
Open the plotter cover.
C
CC
C
Remove the used master roll and
pull out both spools. Then, insert
both spools into a new master
roll.
Note
❒ When the Master End indicator
lights, it is necessary to replace
the master roll even if some
master remains on the old roll.
D
DD
D
The new master roll must be posi-
tioned as shown in the illustra-
tion.
E
EE
E
Set the paper edge of the master
roll as shown.
Note
❒ Rotate the spools backward to
take up any slack in the master.
TSLT010E
PinkGold-F_V4_FM.book Page 68 Tuesday, May 27, 2003 3:33 PM