LCD screen of the GR III (firmware version 1.41 or earlier)
Please use the GR III with the latest firmware.
To update to the latest GR III firmware version, click here
.
LCD screen of GR IIIx and GR III (firmware version 1.50 or later)
・You can switch between Bluetooth® connection and wireless LAN connection by operating
Image Sync.
・For the GR IIIx and GR III (firmware version 1.50 or later), when using Image Sync (version 2.1.8 or
later), the Auto Resize (XS size) transfer function has been added.
・When using the camera with a communication device, please refer to your device's user manual, the
Image Sync website, and the camera's user manual.
Note:
・In the following cases, wireless LAN is disabled.
Movie mode
During USB connection
・If your communication device is iOS, you will need to connect via Image Sync.
・If you set [Connect even when power is off] in the operation mode of the Bluetooth setting,
please note that the Bluetooth signal is transmitted even when the camera is turned off.
To Next Page
Loading...
