Message Cause Solution and reference
"Hardware
Problem: Wireless
Card"
An error has
occurred in the
Wireless LAN
board.
Turn off the power of the machine, check that the Wireless
LAN board is correctly installed in the machine, and then
turn on the power.
page 13 "Turning On and Off the Power"
If the message persists even after you have turned the
power off and then on, consider repairing the machine.
"HDD is full." The area reserved
for forms or fonts in
PostScript 3 is full.
Delete a registered form or font that is no longer
necessary.
"HDD is full. (Auto)" An overflow error
occurred in the
hard disk while
storing a document
printed by Normal
Print as a Hold
Print job by the
error job storing
function.
• Reduce the size of the document to print.
• Erase documents that are no longer needed.
See "Deleting Documents Stored in the Machine",
User Guide (Full Version).
See "Erasing Documents from Document Server",
User Guide (Full Version).
"I/O buffer
overflow."
An overflow has
occurred in the
receive buffer.
• Reduce the transmission data.
• Increase the value in [I/O Buffer] on [Settings]
[Printer Settings] [Host Interface].
"Information for
user authentication
is already
registered for
another user."
In LDAP
authentication, the
same name is
registered under
different IDs on
different servers,
and duplicate
names (account
names) occurred
such as when
switching the
domain (server).
Consult the user administrator. User administrator: Delete
the corresponding user from the address book, and
register the user again after resolving the duplicate names
on different servers.
"Insufficient
Memory"
The amount of
available memory
is insufficient.
Decrease [Resolution] in the printer driver.
See "Applying Different Print Settings Depending on the
Document Type", User Guide (Full Version).
When a Message Appears While Using the Printer Function
285
To Next Page
Loading...
