When the first stage of the process completes, the machine displays the following graphic and then
begins the second stage of the process:
The entire process is complete when the progress bar appears completely shaded and the percentage
indicator shows "100%". The panel returns to the screen that shows the values for the Wipe Disk setting.
Font Sharpening
This setting allows you to set a text point size below which the high-frequency screens are used when
printing font data. For example, at the default 24, all text in font sizes 24 and less will use the high
frequency screens. The values for this setting range from 0 to 150.
To change this setting:
1. Touch "Font Sharpening" from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch "Back" to cancel and return to the Configuration Menu.
4. Touch "Submit" to save the change.
This setting affects the PostScript, PCL, PDF, and XL emulators.
This function is not supported when the device generates output at 600 dpi resolution.
Require Standby
This setting determines if the Standby Mode is "On" or "Off". The default is "On".
Configuration Menu (CONFIG MENU)
157
To Next Page
Loading...
