To change this setting:
1. Touch "Require Standby" from the Configuration Menu.
2. Touch "Back" to cancel and return to the Configuration Menu.
3.
Touch "Submit" to save the change.
If Standby Mode is on, the machine begins functioning in Standby Mode when it remains idle for an
amount of time. The Standby Mode enables the machine:
• To consume less energy than when operating in normal mode but not as little as when operating in
Power Saver
• To return to the Ready state more quickly than when operating in Power Saver
LES Applications
This disables all installed LES applications. The default is "Enabled".
To change this setting:
1. Touch "LES Applications" from the Configuration Menu.
• If an advanced password has been established, you must enter this password in order to
change the setting. If no advanced password exists, you can establish one by using the
keyboard that appears on the LCD.
2. Touch "Back" to cancel and return to the Configuration Menu.
3. Touch "Submit" to save the change.
Key Repeat Initial Delay
When a key is touched repeatedly, this is the delay before the key begins repeating. The delay ranges
from .25 seconds to 5 seconds. The default is 1 second. Values are given in increments of .25 seconds.
To change this setting:
1. Touch "Key Repeat Initial Delay" from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
4. Touch "Back" to cancel and return to the Configuration Menu.
5. System Maintenance
158
To Next Page
Loading...
