User primary message Explanation
35 RES Save Off Deficient
Memory
This message displays when the machine lacks sufficient memory to
enable Resource Save. This message usually indicates the user has
allocated too much memory for one or more of the printer link
buffers; however, modification of other printer settings which affect
the amount of available memory may also create this condition. If
restoration of Resource Save is required after this message is
received, the customer should install additional memory or set each
link buffer to Auto. Once all link buffers are returned to Auto, you
should exit the menu to activate the link buffer changes. Once the
machine returns to the Ready state, you can enable Resource Save
and go back and modify the link buffers again. Note the reduction of
available memory to the link buffers when Resource Save has been
enabled, and compare it to the memory available when Resource
Save is disabled.
• press Select ( ) to disable Resource Save and continue
printing. To enable Resource Save after you get this message:
-Make sure the link buffers are set to Auto, then exit the menus
to activate the link buffer changes.
-When Ready is displayed, enable Resource Save.
• Install additional memory.
37 Insufficient Collation Area
This message is displayed when the printer memory used to store
pages is too full to collate the print job.
The following actions can be taken:
•
Press "Select" ( ) to print the portion of the job already stored,
and begin collating the rest of the job.
•
Press "Menus" (
) to access the Busy/Waiting Menu.
The following functions are available.
-Cancel Job
• Menu Lockout does NOT prevent access to the Busy/Waiting
Menu.
6. Troubleshooting
202
To Next Page
Loading...
