• Faulty/contaminated pick solenoids or worn cams of the solenoids.
• Faulty/contaminated flags or springs.
• Debris in the paper path.
•
Media not of the specified length.
Error Description Action
200.00 Paper jam around input sensor.
Remove the PC kit and paper or debris at
the input sensor.
200.01
Classic input jam. The media is too long over
the input sensor. Possible causes include
multi-sheet feed, tray size sensing problem,
and media slippage.
First, remove the PC kit and paper or
debris at the input sensor. Then, inspect
the flag on the input sensor. It should
rotate freely. Replace the sensor if
necessary. Finally, check the paper size
settings in the machine and the driver.
200.02
The main input sensor never became
uncovered from the sheet ahead.
200.03
The video never started on the page at the
input sensor within two inches after hitting the
input sensor.
Check the printhead. See “Printhead
Service Check” in “Troubleshooting”.
200.04
The media at the input sensor before
interrupt occurred–not enough time elapsed
since the printhead started to expect the
printhead mirror motor lock. Possible causes
include bouncy sensor or exceptionally fast
pick– perhaps due to media pre-staged in
the source tray.
Carefully remove the tray and notice if
the leading edge of the media is pointed
upward and out of the tray. If so, then
inspect the tray wear strips and replace if
necessary.
Inspect the input sensor flag and replace
it if it does not rotate freely or is too loose.
200.06
Imaged page not expected page (bouncy
passthru sensor)
Remove the toner cartridge/PC kit. At the
front, remove the upper front guide, and
inspect the flag on the manual input
sensor. If the flag is loose, then replace it.
See “Media Manual Input Sensor” in
“Replacement and Adjustment”.
200.08
Media reached the input sensor before the
EP was ready
Inspect the tray for prestaging. Verify the
proper media and inspect the tray wear
strips. Replace the wear strips if
necessary.
Messages and Error Codes
209
To Next Page
Loading...
