Error Description Action
200.33
Page from tray 1 did not reach the input
sensor after multiple attempts. Page did
make it out of the tray at least as far as the
manual feeder sensor. Possible cause is that
the page stalled at the alignment gate.
Verify that the pick tires are clean, not
worn, or filled with paper dust. Replace
the pick tires if necessary ( p.40 "ACM
Pick Tire Roller Removal").
The alignment roller may be binding. Call
the next level of support.
200.34
Timed out waiting for page from tray 1 to
reach the input sensor after multiple pick
attempts, but the page was later detected at
the input sensor while waiting for any
page(s) ahead to clear the paper path.
Possible cause is that the page is delayed at
the alignment gate.
200.35 Failed to create hsync during auto alignment
Check the printhead (
p.263
"Printhead Service Check").
200.36 Lost hsyncs during auto alignment
200.37
Timeout on data collection during auto
alignment
200.38
Interpage servo gap is smaller than
expected for printhead offset target
evaluation
200.42
Rogue sheet is at the manual feed sensor
while flushing the paper path prior to
declaring MPF source empty.
Retry alignment.
200.43
The media is at the input sensor before
interruption occurs. Possible causes include
bouncy sensor or an exceptionally small
gap, perhaps due to the media being pre-
staged in the source tray.
Remove the media, realign the stock, and
re-insert. Do not let the top sheets to go
beyond the wear strips.
201.00 Paper jam between input and exit sensor
Remove the toner cartridge/PC kit and
check for obstructions between the input
sensor and the fuser. if the media
continues to stop at the entrance or in the
fuser, then replace the fuser ( p.62
"Fuser Removal").
201.01
Transport motor identification failed to
identify either motor after two tries.
Check the main motor ( p.242 "Main
Motor Service Check").
Messages and Error Codes
213
To Next Page
Loading...
