Error Description Action
241.12
Second pick from manual feeder, tray 1, or
feeder failed when the media was in the
source while other sheets were committed to
the paper path.
Remove the tray and inspect the media
path for obstructions. Check the pick
rollers. Replace the pick rollers if they are
worn or clogged with dust. ( p.40
"ACM Pick Tire Roller Removal"). Also
check the wear strips and the manual
feeder, and replace if necessary.
241.16
Failed to feed from tray 1. Pages in the
paper path have been flushed to the output
bin.
241.17
MISIDENTIFIED SMALL GAP JAM. Engine
detected small gap at the manual feeder
sensor, attempted to open the gap by
stopping the feed rolls, trailing edge was
seen at the input sensor, manual feeder
sensor is no longer covered.
241.19
Second pick attempted failed from Tray 1,
no pages printed since calling a 241.10 or
a prior 241.19.
242.00 Paper jam near tray 2.
Remove Tray 2 and inspect for
obstruction in the paper path. Check the
pick tires for wear or paper dust. Replace
if necessary. Check the wear strips and
replace if necessary.
242.01 Took too long to ramp up dc feed motor
Check the connection with Tray 2. (Lift the
machine and re-set it on Tray 2.) If the
error persists, then replace Tray 2.
242.08
Received lots of dc feed interrupts before
losing them
242.10 Second pick attempt failed from Tray 2
Remove Tray 2 and inspect for
obstruction in the paper path. Check the
pick tires for wear or paper dust. Replace
if necessary. Check the wear strips and
replace if necessary.
242.12
Second pick from manual feeder, tray 1, or
feeder failed when media was in the source,
other sheets were committed to the paper
path.
Check the wear strips and replace them if
worn.
Messages and Error Codes
217
To Next Page
Loading...
