Error Description Action
902.xx Engine software error
Replace the controller board (
p.234
"Controller Board Service Check").
903.xx Paperport link driver error
904.xx Interface violation by RIP
905.xx Interface violation by paperport device
906.xx RIP interface drive error
DC pick motor errors
910.xx DC pick motor stall
911.xx DC pick motor excessive PWM
912.xx DC pick motor below speed
913.xx DC pick motor over speed
914.00 DC pick motor error
914.01 Lost encoder feedback
Transfer service errors
917.xx Transfer service error
Replace the transfer roll ( p.264 "Transfer
Roll Service Check").
Fuser service errors
920.00
Under temperature during steady state
control.
Replace the fuser (
p.240 "Fuser Service
Check").
921.00
Under temperature during standby
control.
922.00 Fuser failed to ramp to target temperature
923.00 Fuser is over temperature.
924.00 Open thermistor check.
925.xx
Wrong fuser installed. The fuser type
stored in the cartridge ID does not match
the actual fuser installed in the machine.
Fan service errors
Messages and Error Codes
223
To Next Page
Loading...
