3. Remove the three screws (A) securing the engine board to the print engine frame.
4. Engine board.
Cover Open Sensor
1. Right side cover( p.104 "Right Side Cover Removal")
2. Disconnect the cable from connector J11 on the controller board.
3. Remove the screw (A) holding the sensor.
4. Cover open sensor.
Door Mount Removal
1. Open the front cover.
2. Lower front cover ( p.69 "Lower Front Cover Removal")
3. Left side cover ( p.66 "Left Side Cover Removal")
4. Right side cover ( p.104 "Right Side Cover Removal")
5. Cable (take it out through the opening).
4. Replacement and Adjustment
52
To Next Page
Loading...
