Problem Causes Solutions
In "Erase Border", "Erase
Inside", or "Erase Outside"
mode, parts of the original
image are not copied.
You have entered a wide
erased margin.
Reduce the margin width. You can set the
border to between 2 and 99 mm (0.1 -
3.9 inches), and you can set the inside
and outside borders individually to
between 0 and 1,220 mm (0.1 - 48
inches).
In "Erase Border", "Erase
Inside", or "Erase Outside"
mode, parts of the original
image are not copied.
Originals are not scanned
correctly.
Place the originals correctly.
Parts of the image are not
copied.
Print Position Adjustment or
Margin Adjustment mode is
selected.
Cancel Adjust Print Position or Margin
Adjustment mode. For details, see
"Margin Adjustment" and "Adjust Print
Position", Copy and Document Server
Reference .
Parts of the image are not
copied.
You placed a custom size
original.
Enter the size of the original, or set the
scanning area wider. For details, see
"Placing Custom Size Originals" and
"Wide Scan", Copy and Document
Server Reference .
In "Image Repeat" mode, the
original image is not copied
repeatedly.
You have entered copy
paper the same size as the
originals, or
you did not select
the proper reproduction
ratio.
Select copy paper larger than the
originals or select the proper
reproduction ratio.
Combine
Problem Causes Solutions
When using "Combine",
parts of the image are not
copied.
You specified a reproduction
ratio that does not match the
sizes of the originals and
copy paper.
When you specify a reproduction ratio
using Manual
Paper Select mode, make
sure the ratio matches the originals and
the copy paper. Select the correct
reproduction ratio before using
Combine mode. See "One-Sided
Combine" and "Auto Reduce/ Enlarge",
Copy and Document Server Reference
.
When You Cannot Make Copies As Wanted
33
To Next Page
Loading...
