Ricoh M052 - Page 261

System SP5-xxx
SM 5-39 M052/M053/M054
System
Maintenance
Reference
5195
[Limitless SW] DFU
001
- *CTL
[0 or 1 / 0 / -]
0: Productivity priority
1: Tray priority
Selects the paper feed mode.
Productivity priority:
This changes the feeding tray as soon as the machine detects the priority tray
even the paper still remains in the feeding tray.
Tray priority:
This changes the feeding tray after the paper in the tray where the machine
has been feeding paper has been run out of.
This SP is activated only when a customer selects the "Auto Paper Selsct".
5199 [Paper Exit After Staple End.]
001 - *CTL
[ 0 or 1 / 0 / -]
0: OFF, 1: ON
Enables or disables the paper feeding out from the finisher without stapling.
 If this setting is "1: ON", paper is fed out without stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
job (over maximum number).
 If this setting is "0: OFF", paper is fed out with stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
job (over maximum number).