SC Tables
M065/M066 3-2 SM Appendix
After you turn the main power switch off, wait for one second or more before you turn the
main power switch on (
SC 672). All SCs are logged. The print log data (SP5-990-004)
in SP mode can check the latest 10 SC codes detected and total counters when the SC
code is detected.
If the problem concerns electrical circuit boards, first disconnect then reconnect
the connectors before you replace the PCBs.
If the problem concerns a motor lock, first check the mechanical load before you
replace motors or sensors.
3.1.2 SC1XX: SCANNING
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
195 D
Serial Number Mismatch
Serial number stored in the memory does not have the correct code.
NVRAM defective
BCU replaced without original NVRAM
1. Reinstall the original NVRAM in the replaced BCU.
2. Turn off and on the main power switch of the copier if a new
NVRAM is installed in the BCU.
To Next Page
Loading...
