Ricoh M065 - Page 356

SC Tables
M065/M066 3-46 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
833
CTL
C
Self-diagnostic error 8: Engine I/F ASIC
[0F30]
[0F31]
 ASIC (Mandolin) for system control could not be detected. After the
PCI configuration, the device ID for the ASIC could not be checked.
Replace the controller board
[0F41]
 ASIC (Mandolin) for system control could not be detected. After the
PCI configuration, the device ID for the ASIC could not be checked.
Replace the controller board
[50B1]
Could not initialize or read the bus connection.
 Check for loose connections at the mother board.
Replace the controller board
[50B2]
Value of the SSCG register is incorrect.
 Check for loose connections at the mother board.
Replace the mother board
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
853
CTL
B
Wireless LAN card not detected
The wireless LAN card is not detected before communication is
established, though the wireless LAN board is detected.
 Loose connection
Check the connection.
⇒
Rev. 10/10/11