Ricoh M065 - Page 419

System Service Mode
SM Appendix 8-9 M065/M066
Appendix:
SP Mode
Tables
078 SP 3:BW:Simplex:Center *ENG
079 SP 3:BW:Simplex:Ends *ENG
080 SP 3:BW:Duplex:Center *ENG
081 SP 3:BW:Duplex:Ends *ENG
082
Target Temp. After Ready *ENG
[100 to 180 / 160 / 1 deg/step]
Specifies the target temperature for the maintain mode after the machine has
reached the target temperature in warm-up mode.
083
Recovery Target Temp. *ENG
[100 to 180 / 160 / 1 deg /step]
Specifies the target temperature for the print mode without printing job after the
machine's recovery.
087 Thick 2: FC: Simplex: Ends *ENG
[100 to 180 / 140 / 1 deg/step]
088 Thick 2: BW: Simplex: Ends *ENG
089 Thick 3: FC: Simplex: Center *ENG
[100 to 180 / 160 / 1 deg/step]
090 Thick 3: FC: Simplex: Ends *ENG
091 Thick 3: BW: Simplex: Center *ENG
092 Thick 3: BW: Simplex: Ends *ENG
109 M-Thick:FC:Simplex:Center *ENG
[100 to 180 / 175 / 1 deg/step]
110 M-Thick:FC:Duplex:Center *ENG
111 M-Thick: BW: Simplex:Center *ENG
112 M-Thick: BW: Duplex:Center *ENG
113 M-Thick: FC: Simplex: Ends *ENG
114 M-Thick: FC: Duplex: Ends *ENG
115 M-Thick: BW: Simplex: Ends *ENG
116 M-Thick: BW: Duplex: Ends *ENG
120 Plain2: FC: Simplex:Center *ENG
[100 to 180 / 160 / 1 deg/step]
121 Plain2: FC: Simplex:Ends *ENG