Ricoh M065 - Page 429

System Service Mode
SM Appendix 8-19 M065/M066
Appendix:
SP Mode
Tables
009 Pattern 2: MM: P-Roll *ENG
[0 to 60 / 50 / 1 deg]
010 Pattern 2: HM: H-Roll *ENG
[-30 to 0 / -5 / 1 deg]
011 Pattern 2: HM: P-Roll *ENG
[0 to 60 / 50 / 1 deg]
1119 [Fusing FF Control] DFU
001 to
020
Specifies the additional duty to the heating roller fusing lamp for each paper
type. These values are added to the duty decided by the PID control.
001 Plain: Center *ENG
[0 to 100 / 50 / 1 %]
002 Plain: Ends *ENG
003 Thin: Center *ENG
[0 to 100 / 35 / 1 %]
004 Thin: Ends *ENG
005 M-Thick: Center *ENG
[0 to 100 / 80 / 1 %]
006 M-Thick: Ends *ENG
007 Thick1: Center *ENG
[0 to 100 / 75 / 1 %]
008 Thick1: Ends *ENG
009 Thick2: Center *ENG
[0 to 100 / 35 / 1 %]
010 Thick2: Ends *ENG
011 Thick3: Center *ENG
[0 to 100 / 40 / 1 %]
012 Thick3: Ends *ENG
013 OHP: Center *ENG
014 OHP: Ends *ENG
015 SP 1: Center *ENG
[0 to 100 / 80 / 1 %]
016 SP 1: Ends *ENG
017 SP 2: Center *ENG
[0 to 100 / 75 / 1 %]
018 SP 2: Ends *ENG
019 SP 3: Center *ENG
[0 to 100 / 40 / 1 %]