Ricoh M065 - Page 576

System Service Mode
M065/M066 8-166 SM Appendix
2873
[Special 3: T-Edge Correct] DFU
Special 3 Paper: Trailing Edge Correction
Adjusts the correction to the paper transfer roller current for the paper trailing
edge in each mode. SP2852 and SP2857 are multiplied by these SP values.
Low: 85 mm/sec
 The paper trailing edge area can be adjusted with SP2874.
003 Paper Transfer: Low: 1st *ENG
[0 to 995 / 100 / 5%/step]
004 Paper Transfer: Low: 2nd *ENG
007 Separation DC: Low: 1st *ENG
008 Separation DC: Low: 2nd *ENG
2874
[Special 3: Sw Timing: T-Edge] DFU
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge
plate at the paper trailing edge between the erase margin area and the image
area.
Low: 85 mm/sec
003 Paper Transfer: Low: 1st *ENG
[0 to 50 / 0 / 2 mm/step]
004 Paper Transfer: Low: 2nd *ENG
007 Separation DC: Low: 1st *ENG
008 Separation DC: Low: 2nd *ENG