System Service Mode
SM Appendix 8-179 M065/M066
Appendix:
SP Mode
Tables
004
Repeat Number: ACC *ENG
[0 to 9 / 3 / 1 time/step]
Specifies the maximum number of repeats of the toner density adjustment at
ACC.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low,
and toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
005
Repeat Number: Recovery *ENG
[0 to 9 / 3 / 1 time/step]
Not used
006
Repeat Number: Job End *ENG
[0 to 9 / 4 / 1 time/step]
Specifies the maximum number of repeats of the toner density adjustment at
job end.
0: Disabled, 1 to 3: Repeat number,
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low,
and toner is consumed only when the toner density is too dark.)
6 to 9: Disabled
007
Repeat Number:Interrupt *ENG
[0 to 9 / 0 / 1 time/step]
Specifies the maximum number of repeats of the toner density adjustment
during printing. DFU
008
Toner Supply Coeff. *ENG
[0 to 25.5 / 10 / 0.1 sec/step]
Adjusts the time for the toner supply mode when a toner density is detected to
be low.
009
C-pattern: Bk *ENG
[0 to 255 / 5 / 1 time/step]
Specifies the belt mark generating time for checking the black toner density
when toner density is detected to be low at the toner density adjustment.
To Next Page
Loading...
