shooting
User primary message Explanation
54 Standard Network
Software Error
This message is displayed when the RIP software detects
that a network port is installed but cannot establish
communications with it.
Press "Select" (
) to clear the message and continue
printing. The job may not print correctly.
Program new firmware for the network interface.
Turn the machine power off and then back on to reset
the machine.
54 Network <x> Software
Error
The machine disables all communications to the associated
network interface. No data may be received or sent from or
to the associated interface. The user can program new
firmware in the network using the parallel port after this
message clears.
Press "Select" (
) to clear the message and continue
printing. The job may not print correctly.
Program new firmware for the network interface.
Turn the machine power off and then back on to reset
the machine.
55 Unsupported Option in
Slot <x>
An unsupported option is installed in the specified solutions
port. Power off the machine and remove the unsupported
option in the specified slot.
Remove the unsupported option.
56 Parallel Port <x>
disabled
This error displays when data is sent to the machine across
an optional parallel port, but the port has been disabled.
Once this message displays, reporting of further errors is
suppressed until the menus are entered, or the machine is
reset.
56 Serial Port <x>
disabled
This error displays when data is sent to the machine across
a serial port, but the port has been disabled. Once this
message displays, reporting of further errors is suppressed
until the menus are entered, or the machine is reset.
To Next Page
Loading...
