and Adjustment
failed, you need to specify settings manually in the SP mode.
13. When the message "Ready" appears on the control panel, switch the power off, and
then remove the AC power plug from the receptacle.
14. Disconnect the flat cable from both FCU boards.
15. Reattach the cover.
16. Reattach the cover.
17. Turn the main power switch on.
18. Enter the SP mode, print the system parameter list from SP6-101 in the Fax SP menu,
and then check the list to see whether the SRAM data has been transferred correctly.
4.12.2 SPEAKER
1. Right Cover (page 4-8 "Right Cover")
2. Remove the five screws of the bracket [A] ( x 5), then remove the FCU board [B] with
bracket (
x 1, x 1)
3. Controller Box [A] (
x4, x2)
4. Speaker [A] ( x2)
To Next Page
Loading...
