Service Call
M160/M161 6-106 SM
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC994-00 C
Operation error caused by abnormalities that are normally
undetectable.
An error occurred because the number of records exceeded the
limit for images managed in the service layer of the firmware.
This can occur if there are too many application screens open
on the operation panel.
Logging only.
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC995-** D
CPM setting error
Comparison of machine serial number (11 digits) and machine
identification code.
Details:
Machine serial number cannot be identified because of
BICU replacement or malfunctioning.
Machine serial number cannot be identified because of
NV-RAM replacement
Machine serial number (11 digits) or machine identification code
does not match.
Replace the board(s) to match the CPM of the controller
and BICU boards.
Turn the main power switch off and on.
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC997-00 B
Application function selection error
The application has not responded to the set command
created by SCS within a certain period of time.
The application selected ended abnormally.
Software bug
To Next Page
Loading...
