Ricoh M160 - Troubleshooting

Troubleshooting
M160/M161 6-112 SM
6.4 TROUBLESHOOTING
6.4.1 TEST PATTERN PRINTING
Follow the test pattern print procedure below to print a test pattern.
 Do not operate the machine until the test pattern has been printed. Otherwise, an SC
occurs.
1. Enter the SP mode, and then select SP2-109-001.
2. Select the pattern number, and then press [OK].
3. Display the Copy function by pressing [Start] key, and then specify the scanning
conditions for test pattern print.
4. Press [Start] key to print the test pattern.
5. Check the test pattern, and then go back to SP mode.
No. Pattern No. Pattern
0 None 9 Arg. Grid 20mm
1 Vert. (1 dot) 10 Indep. (1 dot)
2 Hori. (1 dot) 11 Indep. (2 dot)
3 Vert. (2 dot) 12 Indep. (4 dot)
4 Hori. (2 dot) 13 Full
5 Grid Vert. 14 Band
6 Grid Hori. 15 Gray 10mm
7 Grid 20mm 16 Gray 20mm
8 Arg. Grid 17 Trim Area