Main SP Tables-1
M160/M161 3-6 SM Appendix
1152
[NipWidthMeasuring]
Checks the fusing nip band.
1-152-001 0:OFF 1:ON E [0 or 1 / 0 / 1 /step]
1159
[FusingJamDetect]
Disables or enables the consecutive jam error for the fusing unit.
When set to "1" (on) this SC code is issued after the 3rd consecutive jam in
the fusing unit.
1-152-001 SCdisplay E*
[0 or 1 / 0 / 1 /step]
0: Not detects SC
1: Detects SC
1801
[Motor Speed Adj]
This SP adjusts the speed of the motor. The motor speed can be adjusted
to correct images that appear scratchy or of uneven density. This can occur
when:
Copying originals with large quantities of black.
Copying originals with a large quantity of black near the trailing edge.
Printing multiple copies of positive/negative (reverse) images.
1-801-011 Exit Reverse E* [-4.0 to 4.0 / 0.0 / 0.1%/step]
1907
[Paper Timing Adj]
Adjusts the timing of paper feed. (A "+" setting broadens paper feed
interval, a “-” setting narrows paper feed interval.)
1-907-005 Reverse Stop Posi E*
[-10 to 10 / 0 / 1mm/step]
Adjusts the reverse stop timing of the
range from the Registration Sensor
OFF to the Paper Exit Inverter motor.
Makes it slower (+) or faster (-) than the
default.
To Next Page
Loading...
