3. Make sure that a target SD card is in SD Card Slot 1 [A]. The application program is
moved to this SD card.
4. Insert the source SD card with the application program in SD Card Slot 2 [B]. The
application program is copied from this source SD card.
5. Turn the main power switch on.
6. Start the SP mode.
7. Select SP5-873-001 "Move Exec".
8. Follow the messages shown on the operation panel.
9. Turn the main power switch off.
10. Remove the source SD card from SD Card Slot 2 [B].
11. Attach the SD card slot cover.
12. Turn the main power switch on.
13. Check that the application programs run normally.
To Next Page
Loading...
