Ricoh M160 - Page 683

Error Codes
M160/M161 Fax Option 27 SM
M160/M161 FAX
OPTION
Code Meaning Suggested Cause/Action
15-94 Incorrect ID Code The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
15-95 Transfer Station Function The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
22-00 Original length exceeded the
maximum scan length
 Divide the original into more than one
page.
 Check the resolution used for scanning.
Lower the scan resolution if possible.
 Add optional page memory.
22-01 Memory overflow while
receiving
 Wait for the files in the queue to be sent.
 Delete unnecessary files from memory.
 Transfer the substitute reception files to an
another fax machine, if the machine’s
printer is busy or out of order.
 Add an optional SAF memory card or hard
disk.
22-02 Tx or rx job stalled due to line
disconnection at the other end
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-04 The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05 No G3 parameter confirmation
answer
Defective FCU board or firmware
23-00 Data read timeout during
construction
 Restart the machine.
 Replace the FCU.
25-00 The machine software resets
itself after a fatal transmission
error occurred
 Update the ROM.
 Replace the FCU.