Ricoh M160 - Page 740

Bit Switches - 3
SM 84 M160/M161 Fax Option
Communication Switch 0C - Not used (Do not change the factory settings.)
Communication Switch 0D (SP No. 1-104-014)
No Function Comments
0-7
The available memory
threshold, below which ringing
detection (and therefore
reception into memory) is
disabled.
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each
fax reception. If the amount of remaining
memory is below this threshold, the machine
cannot receive any fax messages.
If this setting is kept at 0, the machine will
detect ringing signals and go into receive mode
even if there is no memory available. This will
result in communication failure.
Communication Switch 0E (SP No. 1-104-015)
No Function Comments
0-7
Minimum interval between
automatic dialing attempts
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the
machine waits before it dials the next
destination.
Communication Switch 0F – Not used (Do not change the factory settings.)
Communication Switch 10 (SP No. 1-104-017)
No Function Comments
0-7
Memory transmission:
Maximum number of dialing
attempts to the same
destination.
01 – FE (Hex) times