Ricoh M199 - Page 124

Service Menu
SM 4-9 M199/M200/M203/M204
System
Maintenance
Reference
CNG Tone
Detection Time
CNG tone detection time ( RX mode : FAX / TEL,
FAX / TAD Only)
After the line is connected via the external
telephone, the machine can detect a CNG signal
for the time length specified by this setting.
[5 Sec (Default)/ 10 Sec]
CNG Cycles
Number of CNG cycles to be detected
This setting is only effective for FAX/TAD mode.
[1.5 Cycle (Default)/ 2.0 Cycle]
Tone Sound
Monitoring
Determines the period when tones from the line
are monitored.
[No Monitoring/ Up To Phase B (Default)/ All TX
Phases]
RX Settings
Stop/Clear key
Pressing the Stop/Clear key can stop the current
receiving operation. Received data is lost.
[No Functional (Default)/ Functional]
Off-Hook Level
DFU (Designed for Factory Use)
Do not change this setting.
[10V (Default)/ 15V/ 20V/ 25V]
Off-Hook
Detection Period
Sets the Off-Hook detection period.
200 ms (default)
800 ms
Number for
Remote Switch
-
[0 to 9 / - / 1step]
Number of time
to press
-
[1 to 3 / - / 1step]
Period for TEL to
FAX
-
[Limitless / 10 sec / 20 sec / 30 sec/ 40 sec]
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times/ 3 Times/ 4 Times/ 5 Times]