Ricoh M199 - Page 127

Service Menu
M199/M200/M203/M204 4-12 SM
V17 Modem
DFU (Designed for Factory Use)
Do not change this setting.
[Permitted (Default)/ Prohibited]
V34 Settings
Equalizer
These selectors set the equalizer's training level
to be applied if training fails due to poor line
connection.
[Automatic (Default)/ 4 Point/ 16 Point]
Redialing
Resend when a communication error occurs.
[Disabled (Default)/ Not Disabled]
First TX Speed
Sets the first transmission speed choice, before
fallback.
[2400 Bps/ 4800 Bps/ 7200 Bps/ 9600 Bps
/ 12000 Bps/ 14400 Bps/ 16800 Bps/ 19200 Bps/
21600 Bps/ 24000 Bps/ 26400 Bps/ 28800 Bps/
31200 Bps/ 33600 Bps (Default)]
Symbol Rate
This setting limits the transmission speed range in
V.34 mode by masking the desired symbol
rate(s).
[Not Used (Default)/ 3429 Sym/Sec
/ 3200 Sym/Sec/ 3000 Sym/Sec
/ 2800 Sym/Sec/ 2400 Sym/Sec]
Internet Fax
Function
(only for :M204)
Disable/Enable
Decides whether the Internet Fax function is used
or not.
Default: Enabled
Reply-To Setting
Sets “Reply-To” in the SMTP authentication.
Yes: Sets the e-mail address that is usually set in
the “From” field in the “Reply-To” field, and sets
the “Administrator e-mail Address” in the “From”
field.
No: Not set.
Default: No
Prt Rec Txt Mail
Header
Selects whether or not to print the header part of
E-mail.
Default: No