Printer Service Mode
SM Appendix 3-153 D255/D256/M281/M282
1001 Bit Switch
Change the number of PS criterion used by the PS interpereter to
determine whether a job is PS data or not. For details, refer to page 4-1
"Printing Features".
Pattern3: The larger the pattern number, the greater the number of
criterion used.
Pattern1: A small number of PS tags and headers
bit 4 Increase max. number of stored jobs. Disabled
(100)
Enabled
Changes the maximum number of jobs that can be stored on the HDD.
The default (disabled) is 100. If this is enabled, the max. will be raised to
750 or 1000 depending on the model.
bit 5 Not used - -
bit 6
Method for determining the image rotation
for the edge to bind on.
Disabled Enabled
If enabled, the image rotation will be performed as they were in the
specifications of older models for the binding of pages of mixed
orientation jobs.
The old models are below:
- PCL: Pre-04A models
- PS/PDF/RPCS:Pre-05S models
bit 7 Letterhead mode printing
Disabled
Enabled
(Duplex)
Routes all pages through the duplex unit.
If this is disabled, simplex pages or the last page of an odd-paged duplex
job, are not routed through the duplex unit. This could result in problems
with letterhead/pre-printed pages.
Only affects pages specified as Letterhead paper.
To Next Page
Loading...
