0F31 ASIC register error.
0F41 The read/write check done for resident RAM on the EGB can not be done correctly.
50B1 Can not initialize or read the bus connection.
50B2 Value of the SSCG register is incorrect.
• One or more EGB connections loose, damaged, defective
•
EGB defective
842
C
Verify error at NAND-Flash update
A verify error occurred while writing to NAND-Flash when the ROM is being updated
locally or remotely.
• Do the procedure again.
•
If not successful after two attempts, the machine will issue SC819.
851
B
IEEE1394 I/F error
There is an incorrect setting in the driver that prevented correct operation of the interface.
• Check and correct the driver settings.
• Network (PHY) LINK module defective
• PCI interface defective
• IEEE1394 I/F board defective
• Controller board defective
853
B
Wireless LAN Error 1
During machine start-up, the machine can access the board that holds the wireless LAN,
but not to the wireless LAN card.
• Wireless LAN card missing (removed)
•
Wireless LAN connection loose
SC Conditions
205
To Next Page
Loading...
