SC No. Level Error Name/Error Condition/Major Cause/Solution
SC535-00 D Paper Exit Cooling Fan Lock
In the motor ON state, the value of the lock sensor is checked every
100msec.
If a lock signal is not obtained for 50 times consecutively.
• Motor defective
• Connector disconnected
• Harness broken
• IOB defective
• Replace the paper exit cooling fan
• Reset the connector
• Replace the harness
• Replace the IOB
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC540-00 D Fusing Motor: Lock
During motor ON, after checking lock signals for 2sec, a High level was
detected at least 20 times.
• Motor defective
• Connector disconnected
• Harness broken
• IOB defective
• Unit torque increased
• Replace the fusing motor
• Reset the connector
• Replace the harness
• Replace the IOB
5. Troubleshooting
502
To Next Page
Loading...
