1116 [Ends Temp. Correction]
010
Center Temp. 1: 226– ENG [-10 / 10 / 5 / 1 deg/step]
Specifies the temperature correction for the heating roller (center) when the paper width is
226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
011
Ends Temp. 1: 226– ENG [-10 to 10 / 5 / 1 deg/step]
Specifies the temperature correction for the heating roller (ends) when the paper width is
226 mm or more.
The start time of this SP can be adjusted with SP1116-018.
012
Center Temp. 2: 226– ENG [-10 to 10 / 0 / 1 deg/step]
Specifies the temperature correction for the heating roller (center) when the paper width is
226 mm or more.
The start time of this SP can be adjusted with SP1116-019.
013
Ends Temp. 2: 226– ENG [-10 to 10 / 0 / 1 deg/step]
Specifies the temperature correction for the heating roller (ends) when the paper width is
226 mm or more.
The start time of this SP can be adjusted with SP1116-019.
014
Center Temp. 3: –226 ENG [-10 to 10 / 5 / 1 deg/step]
Specifies the temperature correction for the heating roller (center) when the paper width is
less than 226 mm.
The start time of this SP can be adjusted with SP1116-020.
015
Ends Temp. 3: –226 ENG [-10 to 10 / 0 / 1 deg/step]
Specifies the temperature correction for the heating roller (ends) when the paper width is less
than 226 mm.
The start time of this SP can be adjusted with SP1116-020.
016
Center Temp. 4: –226 ENG [-10 to 10 / 0 / 1 deg/step]
Specifies the temperature correction for the heating roller (center) when the paper width is
less than 226 mm.
The start time of this SP can be adjusted with SP1116-021.
8. Appendix: SP Mode Tables
158
To Next Page
Loading...
Need help?
General
