SERVICE PROGRAM MODE TABLES 15 February 2006
5-90
5821 Remote Service Address Japan Only
001 CSS PI Device Code Sets the PI device code. After you change this
setting, you must turn the machine off and on.
002 RCG IP Address Sets the IP address of the RCG (Remote
Communication Gate) destination for call processing
at the remote service center.
[00000000h~FFFFFFFFh/1]
5824
NVRAM Data Upload
Uploads the UP and SP mode data (except for counters and the serial number)
from NVRAM on the control board to an SD card.
Note: While using this SP mode, always keep the front cover open. This
prevents a software module accessing the NVRAM during the upload.
5825 NVRAM Data Download
Downloads data from an SD card to the NVRAM in the machine. After
downloading is completed, remove the SD card and turn the machine power off
and on.
To Next Page
Loading...
