Ricoh MT-C1 - Page 572

15 February 2006 SERVICE PROGRAM MODE TABLES
5-99
Service
Tables
Logout 011
Handles the login request of the login initiator for SBP-2. (1-bit)
Bit0: Off
Bit1: On
OFM: Disable (refuse login). Initiator retry during login. Login refusal on arrival of
login request (standard operation)
ON: Enable (force logout). Initiator retry during login. Login refusal on arrival of
login request, and the initiator forces the login.
Login 012
Enables or disables the exclusive login feature (SBP-2 related).
Bit0: Off
Bit1: On
OFM: Disables. The exclusive login (LOGIN ORB exclusive it) is ignored.
ON: Enables. Exclusive login is in effect.
Login MAX 013
Sets the maximum number of logins from the initiator (6-bits)
[0~63/1]
0: Reserved
63: Reserved
5840 IEEE 802.11b
Channel MAX 006
Sets the maximum range of the bandwidth for the wireless LAN. This bandwidth
setting varies for different countries.
[1~14/1]
Channel MIN 007
Sets the minimum range of the bandwidth for operation of the wireless LAN. This
bandwidth setting varies for different countries.
[1~14/1]
WEP Key Select 011
Determines how the initiator (SBP-2) handles subsequent login requests.
[0~1/1]
0: If the initiator receives another login request while logging in, the request is
refused.
1: If the initiator receives another login request while logging in, the request is
refused and the initiator logs out.
Note: Displayed only when the wireless LAN card is installed.