Ricoh Pro 8300S - Perfect Binder: Thrust Plate Retraction Error; Sc750-47

1.SC Codes
333
Major Cause
 Trimmings buffer motor defective
 Thrust plate sensor defective
 Overload
 Connector damaged or defective
 Buffer full of trimmings
Solution
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the thrust plate sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC750-47
Error Name
Perfect Binder: Thrust Plate Retraction Error
Pattern
D
Error Condition
The paper press plate sensor does not go ON after the trimmings buffer moved to the right for 3 sec.
(blocked by jammed trimming scraps)
Major Cause
 Trimmings buffer motor defective
 Thrust plate sensor defective
 Overload
 Connector damaged or defective
 Buffer full of trimmings.
Solution
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the thrust plate sensor.
 Replace the cutter control board.
 Replace the motor harness.