Ricoh Pro 8300S - Perfect Binder: Cut End Lag Error; Perfect Binder: Trimmer Limit Sensor Error; Sc750-66; Sc750-67

1.SC Codes
346
SC750-66
Error Name
Perfect Binder: Cut End Lag Error
Pattern
D
Error Condition
 When moving from rear to front during cutting, blade sensor 1 does not go OFF after enough time
has elapsed for the blade to move 61 mm.
 When moving from rear to front during cutting, blade sensor 1 does not go OFF after 10 sec. have
elapsed.
Major Cause
 Cutter motor defective
 Blade sensors 1 defective
 Motor/sensor disconnected
 Overload
 Blade is dull and not cutting efficiently
Solution
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Replace the blade.
SC750-67
Error Name
Perfect Binder: Trimmer Limit Sensor Error
Pattern
D
Error Condition
Trimmer limit sensor turns ON.