Ricoh Pro 8300S - Perfect Binder: Glue Level Thermistor Adjustment Value Error; Sc751-16

1.SC Codes
363
Error Condition
Without glue supply, the level of the glue detected by the glue lever thermistor did not lower from the
upper limit level, even after application of 25.42 g.
Major Cause
 Glue clogged, or glue supply defective
 Glue level thermistor connector loose, damaged, or defective
 Thermistor defective
 Slave board defective
 Glue application defective
Solution
 Reconnect the connector.
 Adjust the amount of glue application.
 Replace the gluing unit.
 Replace the slave board.
 Check the gluing unit.
SC751-16
Error Name
Perfect Binder: Glue Level Thermistor Adjustment Value Error
Pattern
D
Error Condition
 Temperature detected by glue level thermistor out of range for lower limit (128°C+-14°C)
 Temperature detected by glue level thermistor out of range for upper limit (142°C+-10°C)
 Glue level thermistor adjustment value for low limit is larger than the upper limit
 Difference between the glue level thermistor adjustment values for lower and upper limits is less
than 5°C
Major Cause
 Master control board EEPROM defective
 Glue level thermistor connector loose, damaged, or defective
 Thermistor defective
 Slave board disconnected, defective
Solution
 Reconnect the connector.