Ricoh Pro 8300S - Main Grip Rotate-To-Binding Position Lag Error; Sc752-54

1.SC Codes
435
Error Condition
When rotating signature to main grip binding position, the MG rotate-to-binding position sensor did not
go ON, even though the MG rotate motor had operated for 2250 ms.
Major Cause
 MG rotate motor defective
 MG rotate-to-binding position sensor defective
Solution
 Reconnect the connector.
 Replace the MG rotate motor.
 Replace the MG rotate-to-binding position sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC752-54
Error Name
Main Grip Rotate-to-Binding Position Lag Error
Pattern
D
Error Condition
When rotating signature to main grip turnover position, MG rotate-to-binding position sensor did not go
OFF, even though the MG rotate motor had operated for 500 ms.
Major Cause
 MG rotate motor defective
 MG rotate-to-binding position sensor defective
 Connector harness loose, damaged, or defective
Solution
 Reconnect the connector.
 Replace the MG rotate motor.
 Replace the MG rotate-to-binding position sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.