Ricoh Pro 8300S - Sc753-13; Sc753-14

1.SC Codes
459
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC753-13
Error Name
Perfect Binder: Book collection buffer HP sensor error
Pattern
B
Error Condition
The book collection buffer HP sensor did not go OFF within the time prescribed for release of the book
in the book buffer.
Major Cause
 Book buffer tray motor connector loose, broken, defective
 Motor overload, defective
 Book collection buffer tray HP sensor loose, broken, defective
 Mechanism blocked by paper scraps
Solution
 Reconnect the connector.
 Replace the book buffer tray motor.
 Replace the book collection buffer tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC753-14
Error Name
Perfect Binder: Book collection buffer tray HP sensor late error
Pattern
B
Error Condition
The book collection buffer HP sensor did not go on even after the book buffer tray moved for 3 sec.