Ricoh Pro 8300S - Sc754-13; Sc754-14

1.SC Codes
510
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC754-13
Error Name
Perfect Binder: Glue Roller HP Sensor Lag Error
Pattern
B
Error Condition
During glue supply, the glue roller HP sensor did not go OFF, even though the glue roller motor was
operating for 2400 ms.
Major Cause
 Glue pellets jammed
 Glue supply motor defective
 Glue roller HP sensor defective
 Connector loose, damaged, or defective
 Slave control board defective
Solution
 Reconnect the connector.
 Replace the glue supply motor.
 Replace the glue roller HP sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC754-14
Error Name
Perfect Binder: Front Door Lock Error
Pattern
B
Error Condition
Front door lock release sensor did not go off, even though the door was locked.